Please wait...


2009 Ford Escape Firing Order

2009 Ford Escape Firing OrderA manual is provided with the Ford Firing Order. It contains instructions on how you can change the engine in the engine of your Ford truck. The Ford Firing Order is an important Ford service document that assists the mechanic in charge to determine and provide the proper firing procedure for the engine. The manual also provides guidelines on how to perform specific things. It’s important to read the guide before you start replacing engine components. If you’re not knowledgeable about the steps and procedures to follow and you are not aware of the steps, you could easily become lost in replacing the parts.

Download 2009 Ford Escape Firing Order

2009 Ford Escape Firing Order

The Ford Firing Order states that first of all the cylinder head must be examined, and the number of cylinders replaced should be identified. The timing pulley, along with the flange of the lifter, and the sleeve must all be checked. It is then necessary to shut off the ignition, so that you will be in a position to determine if there are any leaks coming from these parts. To prevent accidental ignition, you must also disable the vehicle’s parking brake. Then, you should close all windows and seal the garage in order to prevent unwanted access to the Ford Firing Order.

After checking that everything is in order, you are able to begin replacing the cylinder heads. You’ll first have remove the spindle as well as the cylinder head. After that, disconnect the idler from its pulley , by unbolting it. Then, you can pull the spindle off the spindle. It is also recommended to place the spindle on the Ford Firing Order so it can be screwed in.

2009 Ford Escape Firing Order

When you have installed the cylinder head, and its corresponding spindle after which you must connect the idler and the sprocket wires to their respective terminals. It is also recommended to connect the drain and the starter plug wires to their terminals as well. After you’ve completed the above steps make sure you check the safety pin or wires. If you discover anything damaged or missing, you should replace them, in order to ensure that your Ford Firing Order will work properly when it comes in contact with the engine.

Then, you must verify the firing capabilities of your Ford Firing Order. To test this, place the key in the ignition, and then turn the ignition off. If the key fails to start the ignition, then move the key towards the door open until the spring is pulling it towards the closed position. Repeat this process until your key will turn on.

2009 Ford Escape Firing Order

The final step is to check the functionality of your Ford Firing Order. For this, you should open the Ford Firing Order and look for the valve connectors. Find the two screws labeled “CEL”, or “Chassis Engineer Leak”. Take off the screws, and then , you must remove the intake manifold. In order to complete your Ford Firing Order repair, inspect the engine for leaks.

Gallery of 2009 Ford Escape Firing Order

Leave a Comment